Advanced; Digital Input/Digital Output - D-Link DCS-6314 User Manual

Section 3: Configuration
This section allows you to control the behavior of digital input (DI) and digital output (DO) devices. The I/O connector provides the physical
interface for DO and DI that is used for connecting a number of external alarm devices, like IR-Sensors and alarm relays. The digital input is used for
connecting external alarm devices. Once the alarm is triggered, images are recorded and sent by e-mail.
D/I and D/O
The camera sends a signal when an event is
Active State:
triggered, depending upon the status type selected.
N.C. stands for Normally Closed. This means that
the normal state of the circuit is closed. Therefore
events are triggered when the device status
changes to Open.
N.O. stands for Normally Open. This means that
the normal state of the circuit is open. Therefore
events are triggered when the device status
changes to Closed.
Click Save Settings.
D-Link DCS-6314 User Manual

Advanced

Digital Input/Digital Output

61