Symbol is used to identify topics of primary safety concern. Further, a separate section has been included, “Important Safety Instruction,” which deals with accident prevention concepts. User experience provides the best feedback. We, at Hawk Enterprises of Elkhart, Inc., welcome your comments and suggestions.
SAFETY ALERT SYMBOL The above symbol is used to call your attention to instructions concerning your personal safety. Watch for this symbol. It means “ATTENTION! Become alert! Your personal safety is involved!” Read the message that follows and be alert to the possibility of personal injury or death.
GROUNDING INSTRUCTIONS This appliance must be grounded. If it should electrically malfunction, grounding provides a path of least resistance for electrical current to reduce the risk of electric shock. This appliance is equipped with a cord having an equipment grounding conductor and grounding plug. The plug must be plugged into an appropriate outlet that is properly installed and grounded in accordance with all local codes and ordinance.
If you purchased the equipment through a distributor, please contact them first. If you are not satisfied, contact Hawk Enterprises of Elkhart, Inc. and give us the distributor name, purchase date, and the serial number of the product.
IMPORTANT SAFETY INSTRUCTIONS Please read all instructions before using this appliance. When using an electrical appliance, basic precautions should always be followed, including the following: WARNING! To reduce the risk of fire, electrical shock, or injury: Do not leave the appliance when it is plugged in. Unplug the unit from the outlet when not in use and before servicing.
PREPARING FOR USE AND OPERATING THE MACHINE SPOTTING PROCEDURES PRIOR TO OPERATING MACHINE 1. Soak up excess liquids with a towel. 2. Test cleaner on a small, inconspicuous area to make sure it will not damage the carpet fibers. 3. Apply appropriate spotter; follow directions on bottle. 4.
Page 8
AFTER USE WARNING! To reduce the risk of electric shock or injury, unplug the power cord before servicing. 1. Toggle the Power Switch to the MIDDLE position to turn off both the vacuum motor and solution pump. 2. DISCONNECT THE POWER CORD. 3.
TROUBLESHOOTING PROBLEM POSSIBLE CAUSE REMEDY Will not heat but vacuum comes on. Fill water to top edge of lid ring. Water level too low. No solution from spray nozzle tip. Disassemble and clean. Nozzle tip plugged. Check quick-disconnect Reconnect fitting onto machine. fitting.
In order to obtain parts warranty, the following procedures must be followed: 1. All machines are shipped from Hawk Enterprises with a warranty activation card. This card must be completed and returned before your warranty can be activated. The customer is responsible to make sure the card is returned.
Page 16
You have purchased a quality product. Each of its components has been tested and approved for use by the Hawk engineering staff. It is unlikely that you will ever have a warranty claim if you properly maintain your machine. HAWK ENTERPRISES OF ELKHART, INC. PURCHASE DATE _____________ PURCHASE DATE _________________...
Need help?
Do you have a question about the MINI-VACTOR and is the answer not in the manual?
Questions and answers