Unlocking The Sfp Module Latch - Wire Variety - IBM DS5100 Installation, User's, And Maintenance Manual

Protective cap
Figure 109. Unlocking the SFP module latch - wire variety
10. Unplug the power cord from the electrical outlet and then disconnect the power
11. Release the controller levers and remove the controller. Figure 110 shows the
Figure 110. Removing a controller from the DS5100 and DS5300
12. Remove the following cards from the controller you removed in step 11 and
174
IBM System Storage DS5100 and DS5300 Storage Subsystem: Installation, User's, and Maintenance Guide
Wire tab
o
90
c. With the SFP latch in the unlocked position, extract the SFP module.
v For SFP modules that contain plastic tabs, slide the SFP module out of
the port.
v For SFP modules that contain wire tabs, grasp the wire latch and pull
the SFP module out of the minihub port.
d. Replace the protective cap on the SFP module.
e. Place the SFP module into a static-protective package.
f. Replace the protective cap on the port.
9. Remove the strain-relief nut and cable strain-relief clamp from the RAID
controller.
cord from the ac power connector on the controller.
controller sliding from the storage subsystem chassis.
Levers in released
position
Latches
install in the new (replacement) controller:
v Host interface card
SFP module
RAID controllers