Switching On/Off; To Switch The Tv On; To Switch The Tv Off; Standby Notifications - Finlux 37F501 Owner's Manual

Switching On/Off

To Switch the TV On

• Connect the power cord to the 220-240V AC, 50 Hz.
Then the standby LCD lights up (The led will blink
during the standby On/Off).
• To switch the TV on from standby mode either:
" button, P+ or P- or a numeric button
• Press the "
on the remote control.
• Press the control switch on the left hand side of the
TV. The TV will then switch on.

To Switch the TV Off

• Press the " " button on the remote control or hold
the on the TV until shut down, so the TV will switch
to standby mode.
• To power down the TV completely, unplug the
power cord from the mains socket.
Note: When the TV is switched to standby mode,
standby LCD can blink to indicate that features such
as Standby Search, Over Air Download or Timer is
active. The LCD can also blink when you switch on
the TV from standby mode.

Standby Notifications

If the TV switches off while in No Signal mode, the
following on-screen message will be displayed on the
next switch-on:
If the TV switches off owing to the auto power down
feature, the following on-screen message will be
displayed on the next switch-on:

First Time Installation

IMPORTANT: Ensure that the aerial is connected
and a Common Interface module is not inserted
before switching on the TV for the first time
installation.
• When the TV is operated for the first time, the
installation wizard will guide you through the
process. First, the language selection screen will
be displayed:
• Use " " or " " buttons to select your language
and press OK button to set selected language and
continue.
• After selecting the language, "
be displayed, requiring you to set Country, Search
Type, Teletext Language and Scan Encrypted
options.
• By pressing "
you want to set and press " " button to highlight
Search Type option. Use " " or " " to set the
desired search type. Available search types are
digital only, analog TV only and full.
• When set, press "
Use " " or " " to select the desired Teletext
Language.
• Press " " button after setting Teletext Language
option. Scan Encrypted will be then highlighted.
You can set Scan Encrypted as Yes if you want to
scan coded stations. Afterwards select the desired
Teletext Language.
- 9 -
Welcome!" screen will
" or " " button, select the country
" to select Teletext Language.