Operating Elements And Connections - Monacor TVCCD-1622COL Instruction Manual

Please unfold page 3. Then you can always see the
operating elements, connections, and menus de-
scribed.

1 Operating Elements and Connections

1 Zoom buttons for modifying the focal length
"W": reduction of the focal length
The angle of view is wider; the object to be moni-
tored is zoomed out.
"T": extension of the focal length
The angle of view is reduced; the object to be
monitored is zoomed in.
With the OSD menu called, these buttons are used to
select a menu line.
2 Focus buttons for manual focussing of the picture
"N": focussing of objects nearby
"F": focussing of objects far away
If the camera is set to autofocus, it is impossible to
focus the picture manually via the focus buttons.
With the OSD menu called, these buttons are used to
modify a setting.
3 Button ENTER for calling the OSD menu (keep it
pressed for approx. 2 seconds) and to activate the
menu item RESET (factory setting) or EXIT (exit of the
menu)
4 Power LED
5 Terminal strip CONTROL for remote control of the
camera via the RS-485 interface or via five separate
momentary pushbutton switches (see chapter 5.2)
6 Terminal strip Z F M C for remote control via a PTZ
controller (Pan, Tilt, Zoom, see chapter 5.3)
7 Button AUTO for the focus mode:
MF manual focus with the buttons "N" and "F" (2)
AF autofocus (permanently active)
PUSH autofocus just once after modification of the
zoom setting
Each time the button is pressed, AF, MF, or PUSH is
shortly displayed on the screen.
8 BNC jack for the video output, 1 Vpp at 75 Ω
9 Switch TERMINATION for connecting the terminating
resistor in case of remote control via the RS-485 inter-
face
When controlling a single camera, set the switch to
ON; when controlling several cameras set the switch
GB
17