Advertisement
turn off place a container under the engine. Remove the dipstick and open the
drain plug to drain the oil.
b. Remove the oil filter cover and oil filter. Clean the oil strainer and oil filter with
solvent.
c. Inspect the O-ring and replace if damaged.
d. Reinstall the oil filter, O-ring and oil filter cover. Replace the oil strainer,
compression spring, O-ring and drain plug. Then tighten the drain plug and filter
cover bolts to the specified torque.
e. Add oil to the engine with oil and install the dipstick.
Caution:
Be sure no foreign material enters the carnkcase.
f. Warm up the engine for several minutes at idle speed. Check for oil leakage
when warming up the engine for several minutes at idle speed. Check for oil
leakage when warming up.
Caution:
If oil leakage is found , turn off the engine promptly and check for the cause.
Lubrication oil of final gear case
a. Measurement of lubrication oil of gear case.
Place the ATV on a level place. Remove the oil filler bolt and check the oil level. It
should be up to the brim of the hole. If the level is too low ,add oil to raise it to the
proper level.
b. Install the oil filler bolt and tighten to the specified torque:23Nm (2.3m.kg, 17ft. lb)
Advertisement
