Advertisement
before turning in high speed.
The turning speed should not be too high.
As you approach a curve, slow down and begin to turn the direction rod. Then put your
gravity center on the footboard to the outside of the curve and lean your body inside. Make
the engine to maintain an even speed when passing the curve. This maneuver will let the
tyre on the inside of the curve slip slightly.
The turning practice should be in flat area without any obstacles. Improper operation
may make your ATV to go straight. If the ATV doesn't turn, stop it and practice again. If
the riding surface is loose and slippery, move your weight forward.
Once you have learn this technique you can turn your ATV at higher speed.
The sudden acceleration, brake , incorrect body position and too high speed will cause
the ATV to slip. If the ATV slips while passing a curve and the ATV machine leans inward,
you should release the throttle and move your body gravity center to outside of the carve to
avoid tipping over.
Remember: ride at higher speed only after you are thoroughly familiar with the
operation of your ATV.
Climbing slope
Don't ride on slope before you are very familiar with ATV operation skill. Otherwise it
will cause accidents.
Necessary practice is required. When climbing the hill, move your body gravity center
forward and operate according to procedures in operation manual.
Climb the hill according to the method in manual.
Check carefully before climbing.
Do not drive on slippery and loose slope.
Advertisement
