8.11 Inspection And Maintenance Reports - Buderus Logano GB125/22 BE Installation And Service Instructions Manual

8.11 Inspection and maintenance reports

V Initial and date the servicing operations completed.
Service work
1. Check general condition of the heating system
2. Visual inspection and function check of the heat-
ing system
3. Checking fuel and water-carrying components of
the system for:
– Leaks during operation
– Leak test
– Visible signs of corrosion
– Signs of ageing
4. Check the combustion chamber and the heating
surface for contamination; shut down the system
for this step
5. Check condensation heat exchanger for:
– Dirt contamination
– Damaged or hardened gaskets
6. Check burner ( burner documentation)
7. Check combustion air supply and flue pipe for
– Function and safety
– Leaks
– Blockages in the air supply system
– In the case of a concentric combustion air sup-
ply and flue gas pipe, blockage of the conden-
sate outlet
– Clean the condensate drain pipe and trap
8. Check the operating pressure, relief valve and
expansion tank inlet pressure
9. Check function of DHW cylinder and sacrificial
anode ( DHW cylinder documentation)
10. Check programming unit settings (
ming unit documentation)
11. Record the final checks of the inspection work,
incl. measurements and test results
Confirmation of properly completed servicing
Tab. 15 Servicing log
Logano GB125 BE US/CA - Technical specifications are subject to change without prior notice.
The inspection and servicing logs can also be used as
copy masters.
Page Date:______
38
42
45
program-
Company
stamp/signature
Heating system servicing
Date:______ Date:______
Company Company
stamp/signature stamp/signature
8
47