Rear Panel - Sony LMD-1951MD Instructions For Use Manual

*10 The signal cannot operate with PRESET 7 and 8 (see
page 38).
*11 The signal can only operate with PRESET 1 (see page 38).
*12 The signal can only operate with PRESET 6 (see page 38).

Rear Panel

qa
a Rear cover
Before you connect cables to the terminals, remove the
rear cover.
For how to remove the rear cover, see page 17.
b
/I (Equipotential/Function Earth) terminal
(equipotential) terminal
Connects the equipotential plug.
I (function earth) terminal
Connects the earth cable.
c COMPOSITE IN connector (BNC)
Input connector for composite signals.
d Y/C IN connector (4-pin mini-DIN)
Input connector for Y/C signals.
e G/Y IN connector (BNC)
Input connector for G of RGB signals and component Y
(luminance) signals.
1
2 3 4 5 6 7 8
qs qd
*13 When a BKM-256DD is installed, the number of the
input connector is increased.
*14 When a BKM-250TG is installed, the signal can be input.
9 0
qf qg qh qj
f B/P
IN connector (BNC)
B
Input connector for B of RGB signals and P
difference) of component signals.
g R/P
IN connector (BNC)
R
Input connector for R of RGB signals and P
difference) of component signals.
h EXT SYNC IN (external sync input) connector
(BNC)
When this unit operates on an external sync signal,
connect the reference signal from a sync generator to
this connector.
To use the external sync signal, press the function button
that EXT SYNC is assigned (F1 button at the factory
setting).
Location and Function of Parts and Controls
qk
(blue color
B
(red color
R
15