Sony LMD-1951MD Instructions For Use Manual page 16

Note
When inputting a video signal with the jitters, etc. the
picture may be disturbed. We recommend using the
TBC (time base corrector).
i Loop-through output connectors
Outputs the signals input to the input connectors (3 to
8). Connect to the analog input (composite, Y/C,
analog component, analog RGB or external sync) of
equipment, according to the input signal.
When a cable is connected to one of these connectors,
the 75-ohm termination of the corresponding input is
automatically released, and the signal input to the input
connector is output.
j Optional input port
An optional input adaptor can be installed according to
your system configuration (see page 19).
The left side port is A and the right side port B.
Press the A-1, A-2, B-1 or B-2 button to select the
signal.
k AC IN socket
Connect the supplied AC power cord.
l DC 5V/24V IN connector
Connect the DC connector of the optional AC adaptor.
m
/ (power) switch
The power is turned on or off.
The monitor is turned on by pressing side
n PARALLEL REMOTE connector (modular
connector, 8-pin)
Forms a parallel switch and controls the monitor
externally.
When the unit is shipped from the factory, a connector
cover is attached to this connector. Remove it before
using the connector.
For removing the connector cover, see page 19.
For details on the pin assignment and factory setting
function assigned to each pin, see page 37.
CAUTION
For safety, do not connect the connector for peripheral
device wiring that might have excessive voltage to this
port. Follow the instructions for this port.
o SERIAL REMOTE connector (RJ-45)
Connect to the network by using a 10BASE-T/
100BASE-TX LAN cable (shielded type, optional).
When the unit is shipped from the factory, a connector
cover is attached to this connector. Remove it before
using the connector.
For removing the connector cover, see page 19.
16
Location and Function of Parts and Controls
For details on this connector, refer to the Interface
Manual for Programmers (saved in the supplied CD-
ROM, Japanese and English only.)
CAUTION
• When you connect the LAN cable of the unit to
peripheral device, use a shielded-type cable to prevent
malfunction due to radiation noise.
• For safety, do not connect the connector for peripheral
device wiring that might have excessive voltage to this
port. Follow the instructions for this port.
• The connection speed may be affected by the network
system. This unit does not guarantee the
communication speed or quality of 10BASE-T/
100BASE-TX.
p SERIAL REMOTE RS-232C connector (D-sub
9-pin, female)
Connect to the RS-232C control connector on external
equipment connected to the monitor. The monitor can
be operated according to control commands sent from
external equipment connected to it.
For details on the pin assignment and factory setting
function assigned to each pin, see page 37.
For details on this connector, refer to the Interface
Manual for Programmers (saved in the supplied CD-
ROM, Japanese and English only.)
q DVI-D input connector (DVI-D)
Inputs DVI Rev.1.0 applicable digital RGB signal.
.
To view the signals of the SXGA and higher resolution
when the DVI input is selected, use the cable within 3 m
1
(118 inches) in length.
/8
r HD15 input connector (D-sub 15-pin, female)
Inputs an analog RGB video signal (0.7 Vp-p, positive
polarity) and sync signal.
The Plug & Play function corresponds to DDC2B.