Table of Contents
Advertisement
Available languages
Available languages
Note 2: „TARA" function
When total sum of all loads on scale > 4 % of scale´s max weight
capacity ( 200 g when capacity is 5 kg).
LCD will show „0g" each time Z/T is pressed. Icon „TARE" will show
on upper left corner of LCD, indicating „TARE" function is active.
Max. weight capacity is reduced by total weight of all loads.
ALARM TIMER
1)
Press T-SET (P7), the zerro will dispay on first position of time reading „0 - : - - ". Use
buttons P4 and P5 to set the first value of minutes = decimal digit. To confirm and go to the
next digit, press T-SET (P7).
2)
The zerro will display on second position „ 0 0 : - - ". On first position, there will be already
set value. Use buttons P4 and P5 to set the second value of minute = unit digit. To confirm
and go to the next digit, press T-SET (P7).
3)
The zerro will display on third position „ 0 0 : 0 - ". On first and second position, there will be
already set value. Use buttons P4 and P5 to set first value of seconds = decimal digit. To
confirm and go to the next digit, press T-SET (P7).
4)
The zerro will display on fourth position „ 0 0 : 0 0 ". On first, second and third position, there
will be already set value. Use buttons P4 and P5 to set the second value of seconds = unit
digit.
5)
After setting time span, press T-SET (P7) again to start the count down.
6)
Press T-SET P(7) to stop counting down and clear time span.
7)
For new setting start again from 1).
)
When timer counts down to „00:00", alarm will go off in form of „beep" for 60 times and then
the scale will automatically shut off.
9)
Max. time span: 99:59
TEMPERATURE SENSOR
1)
Current temperature is shown at the higher right corner of LCD.
2)
Temperature range: 0~+40 °C
3)
Division: 0.5 °C
4)
Temperature readout is only in °C.
AUTO ShUT OFF
Auto shut-off occurs if display shows „0" or the same reading
for 2 minutes. The scale will switch off automatically.
ENG - 23
ENG
Advertisement
Table of Contents
