Page 1
Users Instructions 400G/L PX (CF) For use in GB and IE DESN 511420 C PLEASE READ THESE INSTRUCTIONS BEFORE USING THIS APPLIANCE raywarranty@aga-web.co.uk 06/15 EOPI 512338...
CONTENTS SECTION PAGE INTRODUCTION FEATURES/ACCESSORIES 4 - 5 INTRODUCTION TO TIMER USING THE AUTOMATIC COOKING FACILITY 7 - 10 USING THE MINUTE MINDER MAIN OVEN OPERATION COOKING WITH YOUR APPLIANCE COOKING CHART CLEANING AND CARE OF YOUR APPLIANCE SERVICING, BURNER RESET, GAS LEAK OR FAULT AND POWER FAILURE NOTE: SMOKE/SMELL EMITTED DURING INITIAL USAGE.
Introduction Thank you for buying a Rayburn Appliance. To get the best from it, please read this leaflet and carefully follow the instructions before using your Rayburn for the first time. Consumer Protection As responsible manufacturers we take care to make sure that our products are designed and constructed to meet the required safety standards when properly installed and used.
Fig. 2 DESN 510558 As a Rayburn user you will soon get used to your individual appliance. Oven Grid Shelves See Fig. 3 To ensure the correct operation of the oven grid shelves, ensure that they are inserted as shown.
Mid-day or evening timing to suit meal times. Alternative third program setting if needed. Note: When using the external programmer, the internal clock within your Rayburn should be in the manual mode. You can still use the minute minder function.
Introduction to Timer • Press and hold the button. Now press the [+] or [-] buttons to increase or decrease the time (Fig. 5). Holding the [+] or [-] buttons for more than 2 seconds will advance/decrease the set time quickly. Release the buttons to set the time of day.
Using the Automatic Cooking Facility AUTOMATIC COOKING CONTROL This can be used to set an automatic cooking programme. It switches the oven on and off at the pre-set times. The maximum length of cooking programme which can be set is 23 hours and 59 minutes e.g. a delay time + cooking time = maximum 23 hours and 59 minutes.
Page 8
Using the Automatic Cooking Facility Fig. 11 DESN 517074 Fig. 14 DESN 517077 Now press and hold the button (Fig. 12) and then Set the oven to the required temperature. When cooking press the [+] button (or [-] button) until the required 'stop is finished [AUTO] will flash and the beeper will sound.
Page 9
Using the Automatic Cooking Facility For an overview of the functions refer to table below. Symbol Function Notes Used with the [+] and [-] Sets the Minute Minder buttons Sets the duration/ Used with the [+] and [-] cook period buttons Sets the end/ Used with the [+] and [-]...
Page 10
Using the Automatic Cooking Facility Using this facility on the Rayburn timer allows the user to select the amount of time the appliance is on and the finish/off time. HINTS ON THE USE OF THIS FACILITY The Rayburn should be COLD before starting any automatic cooking where there is a delay in the start time.
Using the Minute Minder Minute Minder Press and hold the button (Fig. 16), and then press the [+] button (or {-] button) until the length of time you want is shown (Fig. 17). Fig. 16 DESN 517068 Fig. 17 DESN 517069 You can check the time remaining by pressing When the beeper sounds cancel it by pressing any button.
When left on L setting your main oven will maintain a low idling temperature suitable for slow cooking . As the Rayburn is made of cast iron, the time for the appliance to heat up and cool down is longer than with a conventional oven.
Food such as casseroles, meringues and milk puddings can then be cooked satisfactorily. When cooking a casserole or meat dishes in the lower oven always start off cooking somewhere else on the Rayburn first. ie allow casseroles to come to the boil then cook for 5-10 minutes on the hotplate or in the main oven before being transferred to the lower oven.
30-35 mins YORKSHIRE PUDDING 2 or 3 25-35 mins SLOW/FAST ROASTING SEE RAYBURN Depending on Joint COOKBOOK FOR TIMES Shelf Positions are counted downwards ie top shelf is No. 1 position. (See Fig. 3A) The positions are a guide only and can of course be altered...
Look for cleaners carrying the VEA (Vitreous Enamel Association) approval logo as this indicates they can be used on your Rayburn. For stubborn deposits, gentle localised soaking, not flooding is easier than rubbing and hot water and detergent will soften most burnt on stains in about 10 minutes.
Servicing or Fault BURNER RESET If a fault occurs on the burner then it automatically shuts down and the red button on the front plinth will be illuminated. This can be reset, after 10 seconds by depressing the reset button. The reset button is located in the lower plinth panel. OPERATING BY PRESSING WITH FINGER ONLY Please wait at least 10 seconds between resetting the lockout button.
Page 20
With AGA Rangemaster’s policy of continuous product improvement, the Company reserves the right to change specifications and make modifications to the appliance described at any time. Manufactured by AGA Rangemaster Station Road Ketley Telford Shropshire TF1 5AQ England www.rayburn-web.co.uk www.agacookshop.co.uk...