Maverick MV29995 Instruction Manual page 9

Electronic Speed Control Setup
Important !
Hold down the setup
button while turning on
the ESC.
Leave the trigger in the
neutral position.
Press the setup button.
Green LED
LED
fl ashes and a
Beep sound
comes from the
motor.
If the LED on the speed control does not work as described below, the speed control may not be setup correctly. Repeat the
above process.
THE LED STATUS IN NORMAL RUNNING:
a) In normal use, if the throttle stick is in the neutral range,neither the red nor green LED will light.
b) The red LED lights when the car is run forward or backwards and will fl ash quickly when the car is braking.
c) The green LED lights when the throttle stick is moved to the top point of the forward zone (full throttle).
Programmable Mode Settings
PROGRAM
BASIC SETTINGS
1. Running Mode
2. Drag Brake Force
3. Low Voltage Cut-off
4. Start Mode (Punch)
ADVANCED SETTINGS
5. Max Brake Force
6. Max Reverse Force
7. Initial Brake Force
8. Neutral Range
9. Timing
10. Overheat Protection
You must set up the ESC before running the fi rst time. Initial setup, it is not required
before every run.
Move the trigger to full
throttle.
Press the setup button.
Green LED
LED
fl ashes twice.
Beeps twice from
the motor.
PROGRAMMABLE VALUE
1 2
Forward with Forward/Reverse
Brake with Brake
0% 5%
Non-Protection 2.6V/cell
Level 1 (Soft) L2
25% 50%
25% 50%
=Drag Brake
0%
Force
6% (Narrow) 9% (Normal)
0.00̊ 3.75̊
Enable Disable
LED
Move the trigger to full
brake.
Press the setup button.
Green LED
LED
fl ashes three
times. Beeps
three times from
the motor.
3 4 5
Rock
Crawler
10% 20% 40%
3.0V/ 3.2V/
2.8V/cell
cell cell
L3 L4 L5
75% 100%
75% 100%
20% 40%
12%
(Wide)
7.50̊ 11.25̊ 15.00̊
9
Release the setup button
once the Red LED starts to
fl ash
When the process has
fi nished, motor control will be
activated in 3 seconds
No LED Lighting
6 7 8
60% 80% 100%
3.4V/
cell
L9 (Very
L6 L7 L8
Aggressive)
18.75̊ 22.50̊ 26.25̊
9