Specifications - Maverick MV29995 Instruction Manual

This is an extremely powerful brushless motor system. We strongly recommend removing
Caution
your tyres for your own safety and the safety of those around you before performing
calibration and programming functions with this system. Please keep your hands, hair, and
loose clothing clear from the gear train and wheels of an armed high performance system.
Rubber tyres will "expand" to extreme size on a high speed vehicle. DO NOT hold the vehicle in the air and run
it up to full throttle. Tyre failures at that speed can cause serious injury! Make sure your tires are securely glued
to the rims and check them often! Always disconnect the battery from the ESC when you are fi nished using your
vehicle.
The switch on the ESC controls the power that is delivered to the receiver and servos. The controller will always
draw current when it is connected to the battery and will completely discharge batteries if they are connected or
long durations. This may cause failure of your batteries.
Failure to follow these instructions can cause injury to yourself or others. You might also cause
Caution
property damage or damage your kit.
As with any extremely high powered electric power system, the primary limitations to ultimate vehicle performance
are the batteries and connectors.Use the best batteries and connectors you can fi nd. The better the batteries,
the more performance you will have! We do not recommend the use of low quality batteries referred to as "stick
packs". Use of "stick packs" may result in personal injury or fi re.
Model
Continuous Current
Burst Current
Resistance
Application
Motor Limit 2S LiPo /
6 cell NiMh
3S LiPo /
9 cell NiMh
Battery
Built-in BEC
Program Port
Motor Type
Dimension
Weight
MCS-29BL-80WP
80A
540A
0.0004 ohm
1/10 scale On-Road and Off-Road
On-Road: ≥ 5.5T
Off-Road: ≤ 6000Kv
3650 Size Motor
On-Road: ≥ 8.5T
Off-Road: ≤ 4000Kv
3650/3660 Size Motor
4-9 cells NiMh or 2-3S LiPo
1) For 4-6 cells NiMH or 2S Lipo: You needn't change the 5V cooling fan on the ESC;
2) For 7-9 cells NiMH or 3S Lipo: You must change the original 5Vcooling fan to 12V
cooling fan, or supply the 5V cooling fan from the receiver (5-6V);
6V/2A Linear
Multiplexed with cooling fan port
Sensorless Brushless
46*34*35mm
82g
8