Resetting Default Values - Maverick MV29995 Instruction Manual

Program Modes - Continued
Start Mode (Punch)
Max Brake Force
Max Reverse Force
Initial Brake Force
Neutral Range
Timing
Overheat Protection

Resetting Default Values

The ESC can be reset to it default settings at any time. When the ESC is on (not in Setup Calibration or
Programmable Settings modes) and the throttle is in the neutral position, hold the setup button for more than 3
seconds. The red and green LED's will fl ash at the same time 3 times to indicate that the defaults have been reset.
This mode selects the level of "punch" from a standing start.Level 1 is soft,
right up to level 9 which is very aggressive. Please note, If levels 7-9 are
selected, battery packs with low discharge rates or are poor quality will not
be able to supply the needed power. It can also cause the motor to not run
smoothly or tremble.
This mode sets the brakes force applied when the throttle is at full brake. A
very large brake force may slow the car quickly but be aware
it can also do damage to the cars drivetrain.
This mode will set the reverse power applied by the ESC. The higher the value
the quicker the reverse function will be.
This setting refers to the very fi rst part of the braking zone. As default this is set
to equal the Drag Brake Force which will give a smooth transition into braking.
It can also be set higher to allow for a more aggressive braking function initially.
The neutral range is the area around the centre of the throttle movement. This
mode will increase or decrease this area to suit your individual preference.
Different types of Brushless motors will react differently to timing values.
Generally the higher the timing setting the more output power and performance
you will gain. This is however balanced off with less run time, heat build up and
effi ciency of the system. We recommend the default timing as a good balance
of performance and run time.
If the function is activated, the output power will be cut off when the
temperature of the ESC is up to the factory threshold for more than 5 seconds.
When the protection happens, the green LED will fl ash.
11