Y-Axis Calibration - Makita SKR300 Service Manual

8b. Y Axis Calibration
1. Press (4) on detector or remote to pass on Y
axis calibration. The Y LED blink rapidly, then
slowly (indicate that the laser is ready to be
calibrated on this axis).
2. Repeat X Axis Steps 5 to 8 to mark (Y1), (Y2).
3. If the two marks are less than 3mm apart
(0.010%) then jump to Saving the calibration.
4. Mark the spot that's halfway between the two
marks.
5. With Y2 facing the marks, bring the laser beam
up or down to the center mark by using (2) or
(3) on the detector or remote.
Saving the calibration
The laser is now calibrated in the X and Y axis.
Press (14) on keypad or (5) on detector or
remote to save calibration data. If you don't
wish to save the calibration, press the On / Off
key (24) on the laser.
SKR300 (version 1-12-03)
14. 15.
17. 16.
Y1
(2) Up
(3) Down
(4) Change
Axis
(5) Save
Page 24