Calibration; X-Axis Calibration - Makita SKR300 Service Manual

8a. X Axis Calibration
1. Turn the laser off before switching to calibration
mode.
2. Simultaneously press two laser keys, On / Off
and Auto / Man.
3. Release On / Off key.
4. The X LED (23) blink 3 times, then the Y LED (21)
stays on. Release the Auto / Man key.
5. The X LED (23) blink rapidly (indicate the laser is
levelling),then blink slowly (ready to be
calibrated on X axis).
6. Place the laser on a flat surface 30m from a
wall, with X1 is facing the wall.
7. After it's level, mark the location of the beam
(X1).
8. Rotate the laser 180°. After it's level, mark the
location of the beam (X2).
9. If the two marks are less than 6mm apart
(0.010%) then jump to Y Axis.
10. Mark the spot that's halfway between the two
marks.
11. With X2 facing the marks, bring the laser beam
up or down to the center mark by using (2) or (3)
on the detector or remote.
12. Next, check Y axis.
SKR300 (version 1-12-03)

8. Calibration

23. 21.
Y1
(2) Up
(3) Down
(4) Change
Axis
(5) Save
Laser beam direction
X1
Y2
X2
Page 23