Rinsing The Ice Cube Maker - Miele KFN 37692 iDE Operating And Installation Instructions

Cleaning and care

Rinsing the ice cube maker

The ice cube maker and water
supply pipework must be rinsed:
– before using for the first time,
– if the ice cube maker has not been
used for a long time,
– regularly when in continuous use
(at least once a month), to remove
ice residues from the system (to
avoid a blockage of the water
supply) and
– before switching the ice cube
maker off for a long time.
When the "Rinse the ice cube maker"
setting is selected, the ice cube maker
b and the water supply pipework are
automatically rinsed.
The ice cube tray then rotates into the
cleaning position to allow you to dry it
by hand.
Water is collected in the ice cube
drawer a.
58
Make sure that the ice cube drawer is
empty before selecting the "Rinse ice
cube maker" setting. Otherwise the
water will empty onto the contents of
the drawer.
The Rinsing setting can only be
selected when the ice cube maker is
switched on.
^ Touch the settings sensor.
All symbols available for selection
appear in the display and the 0 symbol
flashes.
^ Touch the sensors for setting the
temperature (X or Y), repeatedly until
the ice cube maker symbol ®
flashes.
^ Touch the OK sensor to confirm your
selection.
^ By touching the X or Y sensor, you
can now select the setting you want:
0: the ice cube maker is switched
off
1: the ice cube maker is switched
on
2: set the water volume
3: select the ice cube tray cleaning
position
4: rinse the ice cube maker