Table of Contents
Advertisement
Assembly Instructions
4. CONSOLE RACK and MOTOR COVER INSTALLATION
a. Install Console Rack (A) onto Pedestals R & L by resting Console Rack
tubing on top of Pedestal tubing cradles. See Fig. 4.
CAUTION: Do not pinch cabling during this step.
b. Using 5 mm Hex Key, but do not tighten, eight Shoulder Plates (g),
Bolts-M8 x 40mm (f) and external tooth washers-M8 (d) through
Console Rack tubing and into Pedestal tubing cradles. Once all eight
bolts are installed, then tighten all bolts. You may need to align Pedestal
and Console Rack to install first bolt on both sides.
c. Tighten eight Bolts-M8 x 75mm (b) that secure Pedestals to Frame. See
Fig. 2.
d. Using the 17mm wrench, tighten two Hex Head Bolts until secure
against Pedestal legs. Then tighten two nuts to secure Hex Head Bolts.
See Fig 4-1.
e. Place Motor Cover onto frame. Using a Phillips Screwdriver, install
Motor Cover into Frame with seven Motor Cover screws. Install Motor
Decoration Covers with two screws as shown in Fig. 4.
f. Remove clear film from "GK2200" decals on Pedestal legs.
7
Advertisement
Table of Contents
