Table of Contents
Advertisement
CABLE CONNECTION – FRAME AREA
3.
NOTE: Cables will be labeled near their connector with identifying names such
as those listed below in BOLD TEXT. Also listed in these instructions are the
cable part numbers (KDCA-"xx"), which are called out in each step.
NOTE: Reference Wiring Schematic and Frame Cable Routing Diagram at
the end of these Assembly Instructions. You may remove from packet to aid in
assembly but if you remove we recommend you retain these diagrams with the
instructions for future reference.
Step 3-1
CNTRL Control Cable
i. Route CNTRL Cable (KDCA-2B/XL-1063B) from pedestal
towards small circuit board as shown in Step 3.c picture on page
7 and in Fig 3-1.
ii. Plug CNTRL cable connector into small circuit board.
NOTE: 10-pin connector is polarized. Insert properly.
Assembly Instructions
6
Advertisement
Table of Contents
