Assembly - The Handy THMC-A Operator's Manual

ASSEMBLY

0RGHUQ SURGXFWLRQ WHFKQLTXHV PHDQ WKDW WKHUH LV YHU\ OLWWOH OLNHOLKRRG RI WKHUH
EHLQJ DQ\ SDUWV PLVVLQJ LQ WKH FDUWRQ VXSSOLHG +RZHYHU SOHDVH FKHFN WKH ER[
FDUHIXOO\ EHIRUH FRPPHQFLQJ DQ\ DVVHPEO\ If you are missing any parts please
call our spares helpline: 01793-333212.
Contents:
Power Unit; Spark Plug Wrench; Carry Strap.
Hedgetrimmer Attachment
Brushcutter Head; Metal Guard; Allen Key; Cutting Blade; Blade Retaining Nut; Flange
Washer; Clamp Washer; Cupped Washer.
Pruner Cutting Head; Chain Bar Cover; Chain Bar; Chain; Special Spanner.
Line Trimmer Head; Shield Kit.
Barrier Handle (two sections) with 4 screws and nuts.
$VVHPEOLQJ WKH /RRS +DQGOH
‡ Disassemble the loop handle.
‡ Position the upper handle over the upper shaft just in front of
WKH ¿[HG UXEEHU JULS 7KH ORZHU KDQGOH ORFDWHV RQ WKH XQGHU-
side of the shaft and should line up with the four screw holes
on the upper handle. Secure with four screws, washers and
nuts. Nuts are usually already fitted in the lower handle.
Washers should be located under the screw heads.
$WWDFKLQJ WKH 6KRXOGHU +DUQHVV
‡ Connect the latch on the shoulder harness to the harness loop,
located on the upper shaft.
‡ Adjust the strap length to a comfortable position, making sure that
any excess strap is secure.
)LWWLQJ WKH $WWDFKPHQWV
‡ The attachments connect to the power unit by means of a coupler device.
‡ Loosen the rotating knob on the coupler of the power unit shaft.
‡ Push in the button on the attachment shaft.
‡ Align the button with the guide recess on the coupler and slide the two shafts together
to connect the slot and socket inside the shafts.
‡ Rotate the attachment shaft until the button locks in the positioning hole.
‡ Tighten the rotating knob securely.
Note: If the button does not release completely in the positioning hole, the shafts
are not locked in place. Slightly rotate from side to side until the button locks.
Page 8