Operation - The Handy THMC-A Operator's Manual

OPERATION

6WDUWLQJ WKH 0XOWLFXWWHU
‡ Place the machine on the floor, as this may make it easier to start.
Move the ignition switch to the "on" or I position (see Fig. O).
•
‡ Move the choke lever upwards to the "start" position (for cold start only) (Fig. P).
‡ 3XVK WKH SULPHU EXOE  WLPHV XQWLO WKH SHWURORLO PL[WXUH ¿OOV WKH SULPHU EXOE (Fig. Q)
Squeeze the safety lever, then the throttle; push in the throttle lock button with your
‡
thumb (see Fig. S).
‡ 3XOO WKH UHFRLO VWDUWHU  WLPHV XQWLO WKH HQJLQH ¿UHV (Fig. R)
‡ Push the choke lever down to the "run" position and pull the starter again until the
HQJLQH Vtarts 6TXHH]H WKH WKURWWOH WR UHOHDVH WKH WKURWWOH ORFN
Warning: failure to push the choke to the "run" position after the engine has fired
will flood the engine.
‡ Allow the engine to run idle for about 10 seconds to warm it up.
1RWH ,I UHVWDUWLQJ D ZDUP HQJLQH WKHUH LV QR QHHG WR PRYH WKH FKRNH OHYHU RU
prime the primer bulb.
6WRSSLQJ WKH 0XOWLFXWWHU
‡ Release the throttle trigger and allow the engine to idle for a few moments.
‡ Move the ignition switch to the "off" position (Fig. T).
1RWH 7KH DWWDFKPHQWV PD\ FRQWLQXH WR URWDWH IRU D IHZ VHFRQGV DIWHU WKH HQJLQH
has stopped.
'XULQJ WKH ¿UVW  KRXUV RI ZRUN UXQ WKH HQJLQH DW D PRGHUDWH VSHHG
EQVXUH WKDW DOO QXWV EROWV DQG VFUHZV DUH VHFXUHO\ WLJKWHQHG before every use of the
Multicutter
$OZD\V SRVLWLRQ WKH XQLW RQ WKH RSHUDWRU¶V ULJKW VLGH 8VLQJ LW RQ WKH OHIW VLGH ZLOO
H[SRVH WKH XVHU WR WKH H[KDXVW DQG KRW VXUIDFHV ZKLFK FDQ UHVXOW LQ EXUQs
Page 15