The Handy THMC-A Operator's Manual page 10

ASSEMBLY, cont'd
Brushcutter Attachment:
Fig. 1 Remove the Blade Nut, this nut has a left hand thread so should be turned
clockwise to undo it.
Fig. 2 Remove the Cupped Washer, Clamp Washer and Flanged Washer.
Fig. 3 Remove the 3 Blade Guard Screws with the Allen key.
Fig. 4 Position the Blade Guard over the Blade Guard Screw holes, insert and
tighten the screws.
Fig. 5 Fit the Flanged Washer.
Fig. 6 Fit the Blade over the raised section of the Flanged Washer.
Fig. 7 Fit the Clamp Washer.
Fig. 8 Fit the Cupped Washer.
Fig. 9 Fit the Blade Nut, this nut has a left hand thread so should be turned anti-
clockwise to tighten it.
Fig. 10 Locate the Allen key in the locking hole to stop the shaft rotating and firmly
tighten the Blade Nut with the spanner supplied.
Page 10