Assembly - The Handy THMC-A Operator's Manual

ASSEMBLY, cont'd
Line Trimmer Attachment:
‡ 6OLGH WKH VKLHOG RQWR WKH DWWDFKPHQW VKDIW DQG ¿W RYHU
the bracket, as in Fig. 11.
‡ Fix the bolt through the holes in the tabs on the shield
and the slots in the bracket on the attachment shaft.
‡ 6HFXUH, as shown in Fig. 11, XVLQJ WKH ÀDW ZDVKHU
lock washer and nut
‡ Tighten securely and remove the protective packaging
from the line cut-off blade.
2SHUDWLQJ WKH /LQH 7ULPPHU
‡ Operate the throttle trigger with your right hand and hold the barrier handle with your
left hand.
‡ Always kHHS D ¿UP JULS ZLWK ERWK KDQGV GXULQJ RSHUDWLRQ
‡ The line trimmer should be held at a comfortable position with the trigger handle about
hip height. Adjust the harness to suit.
‡ 0DLQWDLQ D ¿UP IRRWLQJ LQ FDVH WKH PDFKLQH KLWV D VROLG REMHFW DQG NLFNV EDFN
‡ Cut tall grass from the top down to prevent the grass wrapping around the shaft
housing and string head which may cause overheating and damage. If grass becomes
entangled stop the engine completely and remove the grass.
‡ Always position the unit on the operator's right side. Using it on the left side will
expose the user to the exhaust and hot surfaces which can result in burns.
Adjusting the Throttle Cable:
• After releasing the throttle lever, pull the throttle cable.
• The normal play is 1 or 2 mm when measured at the
carburettor side end.
• If the play is too short or long, take off the air cleaner
cover, loosen the locknut (1) and adjust (2).
Page 12