Radius Server Settings; Configuring Wireless Security; Configuring Wep - NETGEAR WN802T Reference Manual

NETGEAR Wireless-N Access Point WN802T v2 Reference Manual
Record the WPA-PSK/WPA2-PSK key ___________________________________
• WPA RADIUS Settings. For WPA, record the following settings for the primary and
secondary RADIUS servers:
Server Name/IP Address: Primary _________________ Secondary __________________
Port: ___________________________________
Shared Secret: ___________________________________

RADIUS Server Settings

You can setup or modify the RADIUS server settings to complement network authentication
security options. The RADIUS server can be used with WPA/WPA2 network authentication.
When using a RADIUS server, the RADIUS server settings must be configured before completing
the Network Authentication security profile (see
"Configuring WPA2 with RADIUS" on page
RADIUS" on page 3-11
Note: The RADIUS server settings only need to be configured once per wireless access
point.
To set up or modify the RADIUS server settings see:
on page 4-13.

Configuring Wireless Security

The following section covers configuration of each of the available wireless security options.

Configuring WEP

To configure WEP data encryption:
1. From the Network Authentication drop-down menu on the Securit Settings screen (see
Figure 3-1), select either Open System or Shared Key.
3-6
3-10, or
for specifics on implementing these security options).
v1.0, September 2008
"Configuring WPA with RADIUS" on page
"Configuring WPA and WPA2 with
"Configuring the RADIUS Server Settings"
3-8,
Wireless Security Settings