Configuring Your Basic Wlan Settings - NETGEAR WN802T Reference Manual

3. Connect an Ethernet cable from the WN802T v2 to the computer.
4. Connect the power adapter to the WN802T v2 and verify the following:
• The PWR power light goes on.
• The Ethernet port of the wireless access point is lit when connected to a powered on
computer.
• The WLAN LED should be blinking.

Configuring Your Basic WLAN Settings

The following section describes how to log in to the wireless access point and configure the basic
WLAN settings.
To log in and configure the WN802T v2 for LAN access:
1. Connect to the WN802T v2 by opening a browser window on your PC and entering http://
192.168.0.233 in the address field. The WN802T v2 Login screen displays (see
2. Enter admin for the user name and password for password, both in lower case letters.
Figure 2-1 Login screen
3. Click Login. The main menu of the WN802T v2 displays as shown in
• When the wireless access point is connected to the Internet, you can click the
Documentation link under the Support menu to view the documentation for the wireless
access point online (see
• When connected to the Internet, you can also click Knowledge Base to access
NETGEAR's knowledge base online.
Installation and Configuration
NETGEAR Wireless-N Access Point WN802T v2 Reference Manual
Figure 6-2).
v1.0, September 2008
Figure 2-1).
Figure 2-2.
2-3