Configuring Wpa2-Psk - NETGEAR WN802T Reference Manual

To configure WPA-PSK:
1. From the Configuration menu select Security and from the side menu select Security
Settings.
2. From the Network Authentication drop-down menu, select WPA-PSK. By default, Data
Encryption will be set to TKIP+AES (see
3. Enter the preshared key passphrase (Network Key).
4. Wireless Client Security Separation is disabled by default. If enabled, associated wireless
clients will not be able to communicate with each other. (This feature is intended for hotspots
and other public access situations).
5. Click Apply to save your settings.

Configuring WPA2-PSK

Not all wireless adapters support WPA2. Furthermore, client software is required on the client.
Make sure your client card supports WPA2. Consult the product document for your wireless
adapter and WPA2 client software for instructions on configuring WPA2 settings.
Figure 3-7 WPA2-PSK security settings
To configure WPA2-PSK:
1. From the Configuration menu select Security and from the side menu select Security
Settings.
Wireless Security Settings
NETGEAR Wireless-N Access Point WN802T v2 Reference Manual
Figure
v1.0, September 2008
3-6).
3-13