Fujitsu fi-4860C Operator's Manual page 248

(4) At <Screen51-2>, select the right most item, [200] in the sample screen, and press
(Enter button). Then the LCD display shows <Screen51-2.4>.
At this screen, press
resolution. Following parameters can be specified.
200:
240:
300:
400 sheets:
Press (Enter button) and confirm the setting. Then <Screen51-2> is
redisplayed.
(5) Press (Enter button). Then <Screen51-1> is redisplayed.
At <Screen51-1>, select [START] and press
If fi-486PRFR and/or fi-486PRREis installed, <Screen51-3> is displayed for you to
setup imprinter test conditions.
If an imprinter(s) is not installed, the scanner starts scanning operations.
6) At <Screen50-3>, press
[On] to do imprinter test while scanning.
Then, select the imprinter to use.
If the printer to use is fi-486PRFR, select [Pre].
If fi-486PRRE, select [Post].
If imprinter test is not required, select [Off].
<Screen51-2.4>
R
E S O
(Left arrow button) or
Scan at 200 dpi
Scan at 240 dpi
Scan at 300 dpi
Scan at 400 dpi
<Screen51-3>
P r
= O f f / O
(Left arrow button) or
L U T I O N
0
2 0
(Right arrow button) and select scan
(Start button).
i n t
n : P r e / P
(Right arrow button) and: Select
7.5 Test Mode Details
7
o s t
225