Table of Contents
Advertisement
b. If your service provider uses PPPoE, select Encapsulation as PPPoE, and enter these
additional parameters:
– If your connection supports multiple ISPs, enter the Service Name of the one you use.
Otherwise leave Service Name blank.
– Enter the user name and password provided by your ISP. These fields are case sensitive.
– If you wish to change the login timeout, enter a new value in seconds.
Proceed to Step 7.
c. If your service provider is RoadRunner AND you are required to run a RoadRunner login
program, leave Encapsulation as Ethernet and select Service Type as either RR-Manager or
RR-Toshiba. Enter these additional parameters:.
– If your cable modem is Toshiba, select RR-Toshiba. Otherwise select RR-Manager.
– Enter the user name and password provided by your ISP. These fields are case sensitive.
– If RoadRunner provided an authentication server address, enter it as Login Server
IP address. Otherwise, leave this field as 0.0.0.0.
Not all RoadRunner regions require a login program. If your region does not require a login,
leave Service Type as Standard.
7. Click on Next to go to the final Wizard screen shown below.
a. WAN IP Address Assignment: Unless your ISP has assigned a fixed permanent IP address for
your use, select "Get automatically from ISP". Otherwise, enter your IP Address, Subnet
Mask, and the IP Address of your ISP's gateway router.
Advertisement
Table of Contents
