Kärcher BD 530 Manual page 9

Operating Instructions BR/BD 530/530 XL
Stopping and switching off
the unit
n Close control knob for water flow rate.
n Move the unit forwards another 1–2 m to
extract any remaining water.
n Switch off the switch for suction feed
operation.
n Raise the suction bar.
n Swivel down the running gear and lock.
n Set master switch to "0" and pull out
mains plug.
Caution!
When work is complete, the disc
brushes or the brush rollers must be
unloaded (risk of deforming the brushes).
Draining the dirty water
Caution!
Observe local regulations for the
treatment of waste water.
n Take the drainage hose out of the holder
and place in a suitable receptacle. Drain
off the dirty water by opening the
metering equipment. Then rinse out the
dirty-water tank with fresh water.
22
Drain off the fresh water.
n Open the latch on the fresh-water tank
with a suitable implement (e.g. a coin).
Adjusting the suction bar
Rotating the suction bar
To improve the pick-up result on ceramic
floors (crevices), the suction bar can be
rotated by up to 5°:
n Loosen the star knobs.
n Rotate the suction bar.
n Tighten the star knobs.
English