Adjusting The Device - ABB M22301 series Manual

ABB-Welcome
Pos : 70 /DinA4 - Anl eitungen Onli ne/Ueberschriften/2./Geraeteei nstellungen @ 18\mod_1302768847744_15.doc x @ 103548 @ 2 @ 1
4.5

Adjusting the device

Pos : 71 /DinA4 - Anl eitungen Onli ne/Ueberschriften/3./Absc hlus s widerstand @ 19\mod_1321958079906_15.doc x @ 110083 @ 3 @ 1
Pos : 72 /DinA4 - Anl eitungen Onli ne/Inhalt/KN X/D oor Entr y/Bedienung/Absc hl uss widerstand setzen 83220-AP- xxx @ 19\mod_1310723392369_15.doc x @ 107841 @ @ 1
Fig. 24:
Pos : 74 /DinA4 - Anl eitungen Onli ne/Inhalt/KN X/D oor Entr y/Bedienung/Master/Sl ave Schalter s etz en 83220-AP- xxx @ 19\mod_1310723320966_15.doc x @ 107833 @ @
1. Station
Jumper to set the address of default outdoor station.
2. X100 X10 X1
Jumper to set the address of the indoor station.
EXAMPLE: setting address 024.
3. Master /Slave function
Only one indoor station in each apartment must be set as "Master" (Jumper should
be set as 'M/S on'). All additional indoor stations in the same apartment must be
set as "Slave" (Jumper should be set as 'M/S off').
4. Terminal resistor
In video installations or mixed audio and video installations, the Jumper must be
set as 'RC on' on the last device of the line.
5. a b = Bus connection
= Door bell connection
DC GND = Additional power supply
Pos : 75 /Busc h-J aeg er (Neustr uktur)/Modul- Struktur /Online-Dokumentati on/Steuermodul e - Onli ne-D okumentation (--> F ü r all e D okumente <--)/++++++++++++ Seitenumbruc h ++++++++++++ @ 9\mod_1268898668093_0.doc x @ 52149 @ @ 1
|
— 34 —