Related Manuals for EcoQuest Ozone Blaster 2
Summary of Contents for EcoQuest Ozone Blaster 2
- Page 1 Ozone Blaster 2 By EcoQuest 3500/7000 mg/hr. Ozone Generator Commercial Air Purifier OWNER’S MANUAL Please read all of the information provided in this owner’s manual before operating your new Commercial Air purifier.
- Page 2 CAUTION RISK OF ELECTRICAL SHOCK DO NOT OPEN ATTENTION Caution: TO REDUCE THE RISK OF ELECTRICAL SHOCK, DO NOT REMOVE COVER. NO USER SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVCE PERSONNEL. This “bolt of lightning” indicates that uninsulated material within your unit may cause an electrical shock.
- Page 3 Utilizing controlled corona discharge ozone technology developed specifically to reduce odors and smoke in unoccupied spaces, ideal for treatment of homes, offices, automobiles, boats and More! Model: Ozone Blaster 2 Europe AC 220-240V/50-60Hz Rated Voltage: USA/Japan AC 100-120V/50-60Hz Power Consumption:...
- Page 4 Operating your Ozone Blaster 2 (Front View) Timer Control Knob Turn clockwise to set the timer for timed operation up to hours. Indicator Light Illuminates when unit is in operation. High-low switch ozone high and low change-over switch...
- Page 5 (Back View) Fuse Holder Houses removable fuse. (Two amp, 0.79 inch in length) Power Cord Grounded cord...
- Page 6 Ozone Blaster 2 removes odors, bacteria, mold and viruses in unoccupied spaces. The unit has a timer that will enable it to run for a maximum duration of 2 hours. The timer will then shut the purifier off. To operate the Ozone Generator Air Purifier: ...
- Page 7 When your Ozone Blaster 2 no longer produces enough ozone, replace the ozone plates. (Usual replacement after 6000 hours of operation) How to replace the ozone plate: 1) Turn the unit off and unplug from outlet. 2) Use a screwdriver to unfasten cover screw and remove cover.
- Page 8 If you suspect a problem with your unit check the following: Unit plugged in properly. Unit is properly grounded to avoid potential shock. Fuse is installed properly and in good condition. To replace fuse, pull out the plastic fuse holder, remove old fuse and insert new fuse.
Need help?
Do you have a question about the Ozone Blaster 2 and is the answer not in the manual?
Questions and answers