Step 4: Verifying Operation; When Using Realshot Manager Advanced As A Remote Client - Sony NSR-1000 Series Installation Manual

Step 4: Verifying
Operation
After basic configurations are finished, make sure that
camera images are displayed in the "Main" screen and
verify other such operations.
3
1 Change the layout and display images from
registered cameras.
Drag and drop a camera from the Cameras pane to
a monitor frame to display images from that
camera.
2 Click a monitor frame to activate it (light blue
frame), and control pan, tilt, and zoom from the
[Control] tab of the Camera Control pane.
3 Capture a moving object with the camera, and
confirm that an alarm occurs.
When alarm recording has been configured through
basic configuration, a red frame surrounds the
monitor frame, and a record of each alarm is
displayed in the Alarm History at the bottom of the
screen.
4 Refer to the Monitoring Window Operations Guide
(separate document) for details on operating each
function.
5 Click [PLAYBACK] to play back recordings.
When you click [PLAYBACK], images from a
previously configured time will be played back
(quick playback).
When you enter a date and time and click [GO],
recorded images will be played back.
6 Click the [ERROR] lamp at the bottom right of the
screen to confirm whether errors have occurred.
As the System Log appears when you click the
[ERROR] lamp, you can confirm whether problems
have occurred by viewing the log.
For details on "Main" screen operations, refer to the
Monitoring Window Operations Guide (separate
document) or the User's Guide (PDF).
1
5
2
6
Caution
When you connect a USB device to the unit, the
[ERROR] lamp at the bottom right of the "Main" screen
may light. This indicates that the unit may not support
the USB device. For details see "Usage Precautions"
(page 3) or "An external device connected to a USB
connector does not work." (page 40) in the
"Troubleshooting" section.
When Using RealShot Manager
Advanced as a Remote Client
Perform the following to confirm operations.
1
Log on to RealShot Manager Advanced.
• Specify the server during logon. Specify the
central server value configured on the server for
the port.
The default value is "8082."
If the IP address of the server is "192.168.1.1,"
specify "192.168.1.1:8082" as shown below.
• Enter the user name and password configured in
the Server Configuration screen (page 32) for the
[User Name] and [Password].
2
In the main screen of RealShot Manager Advanced,
assign images to monitor frames from cameras
connected to the unit.
Two methods are available for assigning cameras.
• Drag and drop a camera connected to the unit
from the Cameras pane to a monitor frame.
• Click a monitor frame to select it, and then
double-click a camera from the Cameras pane.
3
Confirm that images from the camera selected in
step 2 appear in the monitor frame.
33

Step 4: Verifying Operation