Sony NSR-1000 Series Installation Manual page 30

Caution
If you click the [Reload] button, the automatic
search is performed again. Take care because apart
from the user name and password of the
administrator, all of the values you entered up until
now will be replaced with the results obtained with
the automatic search.
When registration completes, the following screen
appears.
6
Click [Finish].
The devices are registered to NSR.
Proceed to "Configuring automatic record settings"
(page 31).
Registering Devices Manually
Specify the IP address of a device to register the device
individually.
1
Select [Advanced Setup], and click [Next].
The Configuration window appears.
2
Click [Device] at the top of the Configuration
window.
The Device Configuration screen appears.
30
Step 3: Settings
3
Click (Add).
The Add Device dialog box appears.
4
Configure each item, and click [OK].
Device Type
Select the model name for the camera.
Normally, select "Auto Connect."
When setting this manually, select the model name.
Name
Enter the name to assign to the camera to be added.
It can be up to 32 characters and consist of
alphanumeric characters and some symbols
(periods (.), hyphens (-), underscores (_)).
IP Address
Enter the IP address or the host name for the
camera.
Port
Enter the port number on the camera side for when
connecting with the camera. The default setting is
"80."
Proxy
Set this when the camera will be accessed via a
proxy server.
Enable
Select the check box, and configure the following
items.
IP Address
Enter the IP address or the host name for the
proxy server.
Port
Enter the port number for the proxy server.