Table of Contents
Advertisement
AXIS Q1775-E Network Camera
Hardware Overview
•
Digital output – For connecting external devices such as relays and LEDs. Connected devices can be activated by the
VAPIX® Application Programming Interface, output buttons on the Live View page or by an Action Rule. The output will
show as active (shown under System Options > Ports & Devices) if the alarm device is activated.
•
Digital input – An alarm input for connecting devices that can toggle between an open and closed circuit, for example:
PIRs, door/window contacts, glass break detectors, etc. When a signal is received the state changes and the input becomes
active (shown under System Options > Ports & Devices).
Note
The I/O connector is connected to the housing (fan/heater) on delivery. In the case of a fan or heater error, an input signal
will be triggered in the camera. Set up an action rule in the camera to configure which action the signal shall trigger. For
information about events and action rules, see Events on page 42.
Audio Connector
The Axis product has the following audio connectors:
•
Audio in (pink) – 3.5 mm input for a mono microphone, or a line-in mono signal.
•
Audio out (green) – 3.5 mm output for audio (line level) that can be connected to a public address (PA) system or an
active speaker with a built-in amplifier. A stereo connector must be used for audio out.
RS485/RS422 Connector
Two terminal blocks for RS485/RS422 serial interface used to control auxiliary equipment such as pan-tilt devices.
SD Card Slot
NOTICE
TICE
NO
NO
TICE
• Risk of damage to SD card. Do not use sharp tools or excessive force when inserting or removing the SD card.
• Risk of data loss. To prevent data corruption, the SD card should be unmounted before removal. To unmount, go to Setup >
System Options > Storage > SD Card and click Unmount.
This product supports SD/SDHC/SDXC cards (not included).
For SD card recommendations, see www.axis.com
Control Button
For location of the control button, see Hardware Overview on page 7 .
The control button is used for:
•
Resetting the product to factory default settings. See page 64.
•
Ensuring the camera is level. Press the button for not more than two seconds to start the levelling assistant and press
again to stop. The status LED and buzzer signal (see page 10) assist levelling of the camera. The camera is level when the
buzzer beeps continuously.
•
Connecting to an AXIS Video Hosting System service. See page 55. To connect, press and hold the button for about 3
seconds until the Status LED flashes green.
•
Connecting to AXIS Internet Dynamic DNS Service. See page 56. To connect, press and hold the button for about 3 seconds.
9
Advertisement
Table of Contents
