AXIS Q1775-E Network Camera
Hardware Overview
1.
Sunshield adjustment screw (2x)
2.
Sunshield
3.
Top cover
4.
Network camera
5.
Network connector (PoE)
6.
Safety wire tab
7.
Cable hole
8.
Bottom cover screws (4x)
9.
Heater Caution! May be hot
10. Bottom cover
11. Cable cover
12. Gasket
13. Network cable (route through wall bracket)
14. Bracket adapter
15. Bracket screws (4x)
16. Bracket adjustment screw
17. Wall bracket
Connectors and Buttons
For technical specifications, see page 69.
Network Connector
NOTICE
NO
NO
TICE
TICE
Due to local regulations or the environmental and electrical conditions in which the product is to be used, a shielded network
cable (STP) may be appropriate or required. All cables connecting the product to the network and that are routed outdoors
or in demanding electrical environments shall be intended for their specific use. Make sure that the network devices
are installed in accordance with the manufacturer's instructions. For information about regulatory requirements, see
Electromagnetic Compatibility (EMC) on page 2 .
I/O Connector
Use with external devices in combination with, for example, tampering alarms, motion detection, event triggering, time lapse recording
and alarm notifications. In addition to the 0 V DC reference point and power (DC output), the I/O connector provides the interface to:
8