Table of Contents
Advertisement
AXIS P1254 Network Camera
Hardware Overview
Connectors and Buttons
For technical specifications, see page 55.
Network Connector
RJ45 Ethernet connector with Power over Ethernet (PoE).
NOTICE
TICE
NO
NO
TICE
The product shall be connected using a shielded network cable (STP). All cables connecting the product to the network shall
be intended for their specific use. Make sure that the network devices are installed in accordance with the manufacturer's
instructions. For information about regulatory requirements, see Electromagnetic Compatibility (EMC) on page 2 .
RJ12 Connector
The RJ12 connector is used for connecting the sensor unit to the main unit. For information on how to shorten the sensor unit
cable see Shorten Sensor Unit Cable on page 9 .
SD card slot
NOTICE
TICE
NO
NO
TICE
• Risk of damage to SD card. Do not use sharp tools, metal objects or excessive force when inserting or removing the
SD card. Use your fingers to insert and remove the card.
• Risk of data loss and corrupted recordings. Do not remove the SD card while the product is running. Disconnect power or
unmount the SD card from the Axis product's webpages before removal.
This product supports microSD/microSDHC/microSDXC cards (not included).
For SD card recommendations, see www.axis.com
Control Button
For location of the control button, see Hardware Overview on page 7 .
The control button is used for:
•
Resetting the product to factory default settings. See page 50.
•
Connecting to an AXIS Video Hosting System service. See page 42. To connect, press and hold the button for about 3
seconds until the Status LED flashes green.
•
Connecting to AXIS Internet Dynamic DNS Service. See page 42. To connect, press and hold the button for about 3 seconds.
LED Indicators
Note
• The Status LED can be configured to be unlit during normal operation. To configure, go to Setup > System Options > Ports
& Devices > LED. See the online help for more information.
• The Status LED can be configured to flash while an event is active.
• The Status LED can be configured to flash for identifying the unit. Go to Setup > System Options > Maintenance .
Status LED
Unlit
Green
Amber
Indication
Connection and normal operation.
Shows steady green for 10 seconds for normal operation after startup completed.
Steady during startup. Flashes during firmware upgrade.
8
Advertisement
Table of Contents
