L】Speaker - Kawai AnyTime X GP Service Manual

【L】Speaker
【L-1】Enclosure
Assembling.Instruction
1. Attach speaker ③ on speaker board ② with
four screws ⑩ .
＊.. O bserve. the. attaching. position. shown. in.
the.drawing.below..
Speaker Installing Position
・ Install the speaker while keeping its
terminals in the position shown in the
drawing
Speaker Terminal
Detail B 1 : 1
Edge of Speaker Grill
2. Attach speaker cushion ④ along the inner diameter of
speaker grill edge of enclosure ① .
＊.Refer.to.Cross.section.A-A.and.Detail.B..
3. Attach the speaker assy assembled in Step 1 on
enclosure ① with four screws ⑧ .
＊.. A ttach.the.speaker.terminal.at.the.position.shown.
in.the.drawing..
Speaker Terminal
Position where speaker cushion is attached
Speaker Grill
Detail B
4. Attach acoustic material (acoustic absorbing material) ⑤ on enclosure ① .
Insert the bass reflex port into the opening, then fasten it with four filament tapes ⑨ .
＊.Attach.the.filament.tapes.at.the.area.shown.in.the.drawing.below.right..
5. Attach enclosure cushion (3) (4) ⑥ ⑦ on the edge of enclosure ① .
＊.Check.the.holes.positions.and.align.them.to.the.outer.border.of.the.enclosure..
Bass reflex port
No.. Description.
1 ENCLOSURE.
2 Speaker.Board.
3 SPEAKER.
4 Speaker.Cushion
5 Acoustic.Material.
6 ENCLOSURE.CUSHION.(3). Enclosure.cushion.(3).
7 ENCLOSURE.CUSHION.(4). Enclosure.cushion.(4).
+.BINDING.TAPTITE.SCREW.
8
P.TITE.
9. Filament.Tape.
+.TRUSS.SELF.TAPPING.
10.
SCREW.TYPE.A
– 7 –
Description Remarks.
Enclosure.
Speaker.board.
Speaker. 12.cm.
Speaker.cushion 5.x.10.5.x.390.
Acoustic.material. 10.x.150.x.180.
+.Binding.taptite.screw.P.tite M4.x.20.
Filament.tape. 12.x.80.
+.Truss.self.tapping.screw.
4.x.10.
type.A.
PN.
933970
918351
815474
816618
816619
811364
811365
812257.
798810.
812257.