Kawai AnyTime X GP Service Manual page 55

【J-4】Installing the Sensor Arm and the Sensor
Detail F
＊ Hammer shank assy, wippen assy, keyboard, etc. are omitted in the drawing.
Screw⑤ + Washer⑥
Detail F
Screw for
adjusting height
Stop rail bracket axis
Assembling.Instruction
1. Insert screws ⑤ to the two end points of sensor (1) assy ③ (from the top), then press
fit nylon washers ⑥ from the bottom to prevent screws ⑤ from dropping.
＊.Refer.to."Position.of.screw.and.washer".in.the.drawing.below.. （.and.so.on）
2. In the same way, attach four screws ⑤ and four nylon washers ⑥ on sensor (2) assy ④ .
3. Insert six sensor arm assys ② on the axes of stop rail bracket assy. (See Detail F)
4. Fasten sensor (1) assy ③ and sensor (2) assy ④ on sensor arm assys ② with six
screws ⑤ .
5. Tighten six screws ⑤ into the height adjust screw socket of stop rail bracket assy,
then fasten sensor (1) assy and sensor (2) assy. (See Detail F)
Position of screw and washer
Screw⑤
No.. Description.
1. Action.Assy..(With.Shutter).
2. Sensor.Arm.Assy.
3. Sensor.(1).Assy.
4. Sensor.(2).Assy.
5. +.BINDING.MACHINE.SCREW. +.Binding.machine.screw
6. Nylon.Washer.
.
.
–  –
Description Remarks.
Action.assy
Sensor.arm.assy
Sensor.arm.(1).assy
Sensor.arm.(2).assy
M3.x.6..Black.
Nylon.washer. t=0.5. 2.7- 7
PN
See.J-3.
916391
909106.[909041]
909343.[909149]
878804
916412
Without. ［.］=.GM,GE,RX-1
With［.］=.RX-2,3,5