Kawai AnyTime X GP Service Manual page 35

【A-5】Contol Box (2)
3
4
5
7
1
Additional.processing.on.damper.guide
＊ . P lace.the.countersink.holes.face.up,.as.shown.in.the.drawing.below,.then.cut.a.length.of.
64.mm.from.the.right.end..
64
2
7
8
6
6
Countersink hole
Assembling.Instruction
1. ③ Perform additional processing on damper guide ③ as shown in the drawing left below.
2. Fasten damper guide ③ on damper adjuster ② with four of screw ④ .
3. Fasten damper adjuster ② on control box assy ① with two of screw ⑥ .
. . ＊ With.a.black.felt.pen,.mark.the.position.of.the.damper.adjuster.as.shown.in.the.drawing.below.
4. Wire the cable and fasten the cable holder ⑤ with one screw ⑥ .
5. Attach Himelon ⑦ on two of the round holes of the rod holde.
6. Attach Himelon ⑧ on the area where the screw end ④ of the HP PWB assy touches.
Damper Adjuster Marking Position
Position of Damper Guide and Cable Holder Holding Screw
Cable holder holding screw
No. Description
1. Control.Box.Assy. Control.box.assy
2. Damper.Adjuster. Damper.adjuster
3. Damper.Guide. Damper.guide
4. SCREW. +.Flat.machine.screw.
5. Cable.Holder. Cable.Holder
+.BINDING.TAPTITE.SCREW.
6. +.Binding.taptite.screw.S.tite M3.x.6.Black
S.TITE.
7. HIMELON. Himelon
8. HIMELON. Himelon
– 3 –
6
6
6
Description Remarks
TM-216-2.(64mm.Cut)
M2.x.6.
0.5.x.4.x.17.5.
0.5.x.4.x.35.
Damper guide
holding screw
PN
See.A-5.(1)
909475.
950711.
798901.
909483.
812271.
816602.
816602.