Inserting The Batteries Into The Remote Control; Setting The Time; Saving The Power In Standby Mode - Sony MHC-DX80 Operating Instructions Manual

Inserting the batteries
into the remote control
Tip
With normal use, the batteries should last for about
six months. When the remote no longer operates the
system, replace both batteries with new ones.
Note
If you do not use the remote for a long period of time,
remove the batteries to avoid possible damage from
battery leakage.

Setting the time

1
Turn on the system.
2
Press CLOCK/TIMER SET on the
remote.
When you set the time for the first time,
proceed to step 5.
3
Press cursor V/v repeatedly to select
CLOCK SET.
4
Press ENTER.
5
Press cursor V/v repeatedly to set the
hour.
6
Press ENTER.
7
Press cursor V/v repeatedly to set the
minute.
8
Press ENTER.
The clock starts working.
Tip
If you have made a mistake or want to change the
time, start over from step 2.
Note
The clock settings are canceled when you disconnect
the power cord or if a power failure occurs.
8
03GET_MHC-DX80.p65 GB
Press DISPLAY repeatedly when the
AA (R6)
power is off.
batteries
Each time you press the button, the
system switches cyclically as follows:
Demonstration t Clock t Power Saving
e
Mode
E
E
e
Tips
• The ?/1 indicator lights up even in the Power
• The timer works in the Power Saving Mode.
Note
You cannot set the time in the Power Saving Mode.
To cancel the Power Saving Mode
Press DISPLAY once to show the
demonstration, twice to show the clock display.
8
Saving the power in
standby mode
Saving Mode.
17/07/2001, 2:47 PM
MHC-DX80 4-232-652-14 (1)