Attaching The Foot Stand (Optional); Connecting The Handset; Connecting The Headset (Optional) - Nortel 1210 User Manual

Attaching the Foot Stand (optional)

Attach the foot stand in the appropriate slots depending on the desired angle for
your IP Phone. If you insert the foot stand into the upper slots, your IP Phone
sits at a 25-degree angle. If you insert the foot stand into the lower slots, your IP
Phone sits at a 55-degree angle.
1. Align the bottom tabs on the foot stand with the position 1 slots or the
position 2 slots on the back of your IP Phone.
In position 1 the IP Phone sits at a 25-degree angle.
In position 2 the IP Phone sits at a 55-degree angle.
2. Press the foot stand into the slots until it snaps into place.
If you install your IP Phone on a wall, do not attach the foot stand.

Connecting the Handset

Use the following procedure to connect the handset to your IP Phone:
1. Plug the end of the handset cord with the short straight section into the
handset.
2. Plug the other end of the handset cord with the long straight section into
the handset jack marked with the handset symbol as shown in
3. (Optional) Thread the cord through the channel in the foot stand (if
installed) so that it exits on the side of the foot stand.

Connecting the Headset (optional)

If you have a headset, you can connect the headset to the IP Phone as given in
the following procedure:
1. Plug the headset cord into the headset jack on the back of the IP Phone
as shown in Figure
2. Thread the cord through the channel in the side of the foot stand (if
installed).
3. Set up the headset according to the headset instructions.
For information on how to use your headset with your IP Phone, refer to Headset.
1.
IP Phone 1200 SIP User Guide
13
Figure 1.