Cable Retention Bracket; Removing The Cable Retention Bracket - Dell DR4300 Owner's Manual

Figure 28. Closing the PCIe card holder latch
1. PCIe card holder
3. PCIe card holder latch
Next steps
Follow the procedure listed in the After working inside your system section.
GUID-4B1B5F0F-60DF-489A-BE91-D9DCAC21B816

Cable retention bracket

Cable retention bracket provides support to the installed cables. The cable retention bracket also helps to
prevent the cables from moving out of place, which may result in loose connections and reduced air flow
inside the server.
GUID-FBFF60A0-2943-444F-8958-B29C29FA11A8

Removing the cable retention bracket

Prerequisites
1. Follow the safety guidelines listed in the Safety instructions section.
2. Follow the procedure listed in the Before working inside your system section.
3. If installed, remove the cooling shroud.
4. Remove the PCIe card holder.
5. Remove all cables routed through the cable retention bracket.
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that are shipped with your product.
Steps
1. Pull the tab to release it from the notch and slide the cable retention bracket toward the front of the
chassis to release it from the chassis.
2. Lift the cable retention bracket out of the chassis.
2. release tab
95