Dell DR4300 Owner's Manual page 54

Option Description
External Serial
Enables you to associate the External Serial Connector to Serial Device 1, Serial
Connector
Device 2, or the Remote Access Device by using this option.
Failsafe Baud Rate Specifies the failsafe baud rate for console redirection. The BIOS attempts to
determine the baud rate automatically. This failsafe baud rate is used only if the
attempt fails, and the value must not be changed. This option is set to 115200 by
default.
Remote Terminal Sets the remote console terminal type. This option is set to VT 100/VT 220 by
Type
default.
Redirection After Enables or disables the BIOS console redirection when the operating system is
Boot loaded. This option is set to Enabled by default.
Related Links
Serial Communication
Viewing Serial Communication
GUID-0CC8F614-DBD3-4971-91CD-37D65FFAB985
System Profile Settings
You can use the System Profile Settings screen to enable specific system performance settings such as
power management.
Related Links
System Profile Settings details
System BIOS
Viewing System Profile Settings
GUID-4B312423-5C9C-4952-A839-01CFC98C1F1A
Viewing System Profile Settings
To view the System Profile Settings screen, perform the following steps:
1. Turn on, or restart your system.
2. Press F2 immediately after you see the following message:
F2 = System Setup
NOTE: If your operating system begins to load before you press F2, wait for the system to finish
booting, and then restart your system and try again.
3. On the System Setup Main Menu screen, click System BIOS.
4. On the System BIOS screen, click System Profile Settings.
Related Links
System Profile Settings
System Profile Settings details
54
NOTE: Only Serial Device 2 can be used for Serial Over LAN (SOL). To use
console redirection by SOL, configure the same port address for console
redirection and the serial device.
NOTE: Every time the system boots, the BIOS syncs the serial MUX setting
saved in iDRAC. The serial MUX setting can independently be changed in
iDRAC. Loading the BIOS default settings from within the BIOS setup utility
may not always revert this setting to the default setting of Serial Device 1.