Dell DR4300 Owner's Manual page 49

Viewing SATA Settings
To view the SATA Settings screen, perform the following steps:
1. Turn on, or restart your system.
2. Press F2 immediately after you see the following message:
F2 = System Setup
NOTE: If your operating system begins to load before you press F2, wait for the system to finish
booting, and then restart your system and try again.
3. On the System Setup Main Menu screen, click System BIOS.
4. On the System BIOS screen, click SATA Settings.
Related Links
SATA Settings
SATA Settings details
GUID-6A121632-4C76-4B06-B845-FB9CA41ACDB1
SATA Settings details
The SATA Settings screen details are explained as follows:
Option Description
Embedded SATA Enables the embedded SATA option to be set to Off, ATA, AHCI, or RAID modes.
This option is set to AHCI by default.
Security Freeze Sends Security Freeze Lock command to the Embedded SATA drives during POST.
Lock This option is applicable only for ATA and AHCI modes.
Write Cache Enables or disables the command for Embedded SATA drives during POST.
Port A Sets the drive type of the selected device. For Embedded SATA settings in ATA
mode, set this field to Auto to enable BIOS support. Set it to OFF to turn off BIOS
support.
For AHCI or RAID mode, BIOS support is always enabled.
Option
Model
Drive Type
Capacity
Port B Sets the drive type of the selected device. For Embedded SATA settings in ATA
mode, set this field to Auto to enable BIOS support. Set it to OFF to turn off BIOS
support.
For AHCI or RAID mode, BIOS support is always enabled.
Option
Model
Drive Type
Description
Specifies the drive model of the selected device.
Specifies the type of drive attached to the SATA port.
Specifies the total capacity of the hard drive. This field is
undefined for removable media devices such as optical
drives.
Description
Specifies the drive model of the selected device.
Specifies the type of drive attached to the SATA port.
49