Care And Cleaning - Zanussi zop38903 User Manual

Care and cleaning

Warning! Refer to the Safety chapters.
• Clean the front of the appliance with a soft
cloth with warm water and a cleaning agent.
• To clean metal surfaces use a usual cleaning
agent.
• Clean the oven interior after each use. Then
you can remove dirt more easily and it does
not burn on.
• Clean stubborn dirt with a special oven
cleaner.
• Clean all oven accessories after each use
and let them dry. Use a soft cloth with warm
water and a cleaning agent.
• If you have nonstick accessories, do not
clean them using aggressive agents, sharp-
edged objects or a dishwasher. It can de-
stroy nonstick coating.
Stainless steel or aluminium applian-
ces:
Clean the oven door with a wet sponge only.
Dry it with a soft cloth.
Do not use steel wool, acids or abrasive materi-
als, as they can cause damage to the oven sur-
face. Clean the oven control panel with the
same precautions.
Shelf supports
You can remove the shelf supports to clean the
side walls.
Removing the shelf supports
1
Pull the front of
the shelf support
away from the side
wall.
www.zanussi.com
2
1
2
Pull the rear end
of the shelf support
away from the side
wall and remove it.
Installing the shelf supports
Install the shelf supports in the opposite se-
quence.
The rounded ends of the shelf supports
must point to the front.
Pyrolysis
Warning! The appliance becomes very
hot. There is a risk of burns.
Caution! If a hob is installed with the
appliance, do not use it at the same times
as the Pyrolysis function. It can cause damage
to the appliance.
1. Remove the removable shelf supports (if
applicable) and accessories from the appli-
ance. Refer to "Removing the shelf sup-
ports".
Caution! Do not let the removable shelf
supports stay in the appliance during the
Pyrolysis. There is a risk of damage.
2. Remove the worst dirt manually.
3. Fully close the oven door.
The cleaning procedure cannot start if you
do not close the oven door.
4. Press
again and again until the display
shows .
– The display shows P1 and
the other.
– An acoustic signal sounds as a reminder
to remove all accessories and shelf sup-
ports from the oven.
– The clock display shows 1:30.
– Duration
flashes.
5. When
flashes, press + or - to set the
necessary procedure:
• P1 - if the oven is not very dirty. The pro-
cedure is 1 h 30 min long.
• P2 - if the oven is more dirty. The proce-
dure is 2 h 30 min long.
one after
17