Vonets vap11g Step-By-Step Manual page 30

message.
7. The yellow light comes on, but the configuration
programme cannot detect the wifi bridge.
> Sometimes Windows needs a refresh of connec-
tions that are already active. When this happens,
deactivate your wired connection and then reacti-
vate it. After you have done this. Remove the wifi
bridge from your PC and reconnect it. Try step one
of the configuration program again and hopefully
this time, the program should be able to detect the
wifi bridge.
8. My wifi bridge does not light up when I plug it
into the USB port. I don't think the USB port has
any power coming out of it.
> In this case, you will need to purchase a separate
12v power supply. These are cheap enough and
you can get them on eBay and at most electrical
retailers, such as Argos. To power the wifi bridge
using a
power connector into the hole (power socket) next
to the base of the wires on the wifi bridge. This
will power the USB.
> If your chosen device already has a power adapter,
you can insert the power adapter socket into the
wifi bridge, pull off the wifi bridge's USB connec-
tor and insert the wifi bridge power connector
concealed underneath the USB connector into your
chosen device's power socket.
power adaptor, fit the power adapter 's