Vonets vap11g Step-By-Step Manual page 29

The other connector is a USB connector which de-
>
rives power from the device to which the wifi
bridge is connected. Underneath the USB connec-
tor is a regular power adapter connector, in case
you do not have a USB port on your device.
4. What is the length of the wires?
Each wire is 30cm in length, therefore the com-
>
bined reach of both wires is 60cm or 0.6m (just
over half a metre or 2 ft)
5. When I run the configuration program, and try to
configure the wifi bridge I get a message saying ,
'NIC not found'.
> Disable your wireless connection on your PC and
then re-run the wifi bridge configuration software.
Make sure your wired connection is activated. You
should not receive the message this time and the
configuration software should be able to configure
the wifi bridge to your wireless network with no is-
sues.
6. Why does the 'NIC not found' message appear?
> The wifi bridge emits wireless signals, so you must
make sure that any device to which it is attached
has its wireless capability turned OFF (this mainly
concerns PCs which can have both wired and wire-
less connections at the same time) and its wired
internet connection turned ON. Failing to do this
will prevent the wifi bridge from being installed or
working properly and you will receive this error