Front Bezel - InFocus X2 Service Manual

Front Bezel

The front bezel (505-1838-xx) covers the front of the projector and helps to secure the top case to the
bottom case. Two screws at the bottom and two tabs and a slotted receiver on the top of the front bezel
hold it in place on the projector. The front IR lens and the inner grill fasten to the inside of the front bezel.
These two parts are not replaceable. When you replace the front bezel, you must remove the lens and
grill, and install them on the new bezel.
The lens cap and tether (505-1843-xx) attach to a tab on the bottom of the front bezel. When you
replace the bezel, you remove the lens cap and tether and install on the new bezel.
1 Remove the following:
Focus and zoom rings (page 17)
Lamp door (page 24)
2 Place the projector upside down on a soft work surface.
3 Remove the two M3x10 Plastite Phillips screws that fasten the front bezel to the bottom case.
X2 Service Manual 18