InFocus X2 Service Manual page 38

4 Turn the projector right side up on the work surface. Firmly pull the side of the rear bezel away
from the projector. If needed, carefully insert the tip of a flat blade screwdriver into the space
between the rear bezel and top case. Position the screwdriver blade at the location of one of the
slotted receivers and press down to release it.
Assembly Notes
♦
Align the rear bezel against the rear of the projector. Press the bezel into position to lock the
three tabs against the top case.
♦
Tighten the two M3x10 and the M2.6x10 Plastite Phillips screws securely. Do not over tighten the
screws.
♦
When you install a new rear bezel, adhere a new I/O panel label to the outside of the bezel.
X2 Service Manual 38